User's Manual

05
2.2. Installation environment requirements
When the equipment is running, please do not block the vents or the heat
dissipation system in order to prevent high temperatures and/or fires.
The equipment should be installed in an area away from liquids. It is forbidden
to install it near or below water pipes, air outlets and other locations that are
prone to water condensation.
It is forbidden to install the unit underneath pipes, windows or other similar
areas that are prone to water leaks in order to prevent liquids from entering into
the equipment. Failure to do so may result in a short circuit.
If liquid is found inside the device, user must turn off the power immediately.
The equipment room must be properly insulated and the walls and floors must
03. What`s in the Box
Standard Accessories
No. Picture Category Quantity
1 EP500Pro Power Station 1
2
AC Charging Cable
Charging EP500Pro via wall outlet
1
3
PV Charging Cable
Charging EP500Pro via solar power
1
4
EP500Pro POWER STATION
Please read th is ma nual bef ore use and follow its g ui dance. Keep this manual for future r efere nce.
User Manual
Please keep it for future reference
1
5
Warranty Card
1
6 1
06
Additional Purchase Accessories
Sold on BLUETTIPOWER.COM
No. Picture Category
7
Split Phase Box Pro (P030A)
To double the capacity, power of output
and voltage.
8
12V/30A XT60 to
Aviation Plug
12V/30A RV Cable
For 30A DC Output.
XT60 to SPC45
To support DC power supply for RV.
9
Generator Charging Cable
Charging EP500Pro via generator.
10
11
Car Charging Cable
Charging EP500Pro with cable No3.
12
T500 500W Adapter
Additional 500W AC charger.
13
AC Charging Cable for Split Phase
Charging two EP500Pro connected in split
phase mode via wall outlet.
14
Charge EP500Pro via roof/rigid panels.
15
Sub Panel
Integrate the power station to your home
circuit as backup UPS.