User Manual

Fishing can be hard on equipment, so if you damage your T-POD (and this is NOT covered by your warranty) you can have it replaced

for a fraction of the original cost. This service also extends beyond the standard warranty period, so if five years from now the battery

is fails, Vexilar's No Hassle Service Program for SonarPhone T-POD owners will be there for you, for as long as you own the product!

Here's how it works: Send us your damaged or destroyed SonarPhone T-POD along with $60.00 US and we will send you back a

replacement T-POD! No questions asked. This cost includes domestic return shipping. Some additional shipping may apply for

customers outside the USA. Credit card payment is also accepted by phone. (Visa and Master Card only)

Send to:

Vexilar, Inc.

6667 West Old Shakopee Rd Suite #101

Bloomington, MN 55438 – USA

Attn: SonarPhone No Hassle Service

IMPORTANT: Be sure to include your name and return address and a phone number or e-mail address for us to contact you.

IMPORTANT: Do not try to open your T-POD, it is permanently sealed. Opening a T-POD will void the warranty.

T-BOX WiFi Permanent Installation (SP200)

To use the T-BOX system (SP200) on a boat, the T-Box and transducer

must first be installed onto the boat and the proper wiring connection

made.

Take a few minutes to plan your installation. The T-BOX should be

mounted in a location where it will be readily accessible yet out

of the way of traffic and sheltered from severe weather exposure.

The mounting surface should be fairly flat. Be sure to allow clearance

for the cables. The unit is weather-proof, not waterproof, so try

not to mount it in a location where it will be submerged or exposed

to the extreme forces of wave impact during severe conditions.

Mounting the T-BOX

1. Obtain four appropriate fasteners for your mounting

location.

2. Position the T-BOX in your intended mounting location.

3. Mark the four holes and drill each using the appropriate

drill size.

4. Attach the T-BOX using your four fasteners. Tighten

securely.

Insert the power cable jack and tighten the transducer

cable connection securely. Ensure there is good clearance

for the connectors.