User Manual

10
stainless steel connection can create rust.
Turning T-POD ON
The T-POD WiFi Sonar System will active
automatically when it is immersed in the water.
The T-POD's internal GREEN indicator light when
it has connected a SonarPhone app successfully.
Once immersed, the internal computer will begin
to start up. Give it a few seconds.
When ready, the T-POD will begin to blink,
indicating it is transmitting the sonar
information via radio frequency (WiFi) for the
SonarPhone app to receive. Connect to it's WiFi
signal using your device settings, then return to
the SonarPhone app to connect to the T-POD.
You can turn your T-POD on at home and test it's functionality:
Dampen a paper towel with cool water.
Bunch it up and place it against the pins on the underside of T-POD.
Watch as the light turns on and then begins to flicker.
Connect to the T-POD with your SonarPhone App. Refer to the WiFi connection
instructions if needed. Make sure the GAIN is at least 70%. (You can remove the wet
towel)
Hold the T-POD about 1 meter above a hard flat floor (not carpet).
Point the flat part of the bottom of the T-POD at the floor and watch for the echo to
appear on your SonarPhone chart. The more perfect your aim at the floor, the stronger
the echo will appear. Increase the gain level if you cannot find a floor echo.
The T-POD will time-out and turn itself off 30 seconds after the pins have dried.
IMPORTANT: The T-POD's "Wet Switch" pins must be rinsed with fresh water after exposure
to salt water to prevent corrosion.
IMPORTANT: Do not place the T-POD in a wet area or on a metal surface when not in use
as this will activate the T-POD, drain it's battery and help shorten its usable life.
Store the T-POD in a dry area.
Resetting Your T-POD To Factory Default
A. The T-pod must be OFF and FULLY CHARGED before resetting.
B. Using the shorter (reset) lead on power charging cable you need to connect to power then connected to your T-POD for at least 10
seconds.
C. Remove the lead from the T-pod, DO NOT CONNECT THE DEVICE (SMARTPHONE) TO THE T-POD immediately. Allow the
T-pod turn off automatically in one minute.
Master Passcode: 12345678
If the device does not accept the factory default passcode please re-peat steps A, B & C (It may take several attempts in some cases.)
Don’t forget to re-establish yourself or device as the Master before you enter the SonarPhone app.
T-POD No Hassle Service Program