Operation Manual

5. Adjustment of Massage Strength
Press “Up” and “Down” to select “ ”, then press “ ” right button to
increase massage strength, press once to increase one grade with total 16
grades, corresponding figure will be displayed on the screen; press “ ”
left button to decrease massage strength and the corresponding figure will
be displayed on the screen. The default strength is “0” grade as power-on.
Massage shall be subject to acceptable strength. For initial use, please adjust
the strength gradually and shall subject to comfortable strength.
7. Use of Heating Function
Press “Up” and “Down” to select “ ”, then press “ ” right or left button to
switch among Low Heat (1), Moderate Heat (2) and High Heat (3) mode,
corresponding mode will be displayed on the screen. “0” refer to stop heating,
and it is defaulted to be moderate heat. The red light and the heat are turned
on synchronously, and the brightness does not change depending on the
heating position.
8. Adjustment of Timing Time
Press ”Up” and “Down” button to select “ ”, then press “ ” right or left
button to switch among three heating modes with the working time of 5 to
30 minutes, the default time is 15 min as power-on before power-off. Press
power switch “ ” to restart.
Press “Up” and “Down” to select “ ”, then press “ ” right or left button to
switch among 6 modes. The default mode is Mode 1 as power-on (Automatic
Combination 1 Mode), corresponding mode will be displayed on the screen.
These massage modes are shown below:
6. Switch of Massage Modes
Automatic Combination Mode 1 and 2 are manual modes after automatic cycle,
which is switched automatically each minute, it is recommended to use automatic
combination mode.
Mode 1: Automatic Combination 1, Circulation Mode 3, Mode 4, Mode 5;
Mode 2: Automatic Combination 2, Circulation Mode 4, Mode 3, Mode 6;
Mode 3: Simulated Manipulation Massage;
Mode 4: Simulated Acupressure Massage;
Mode 5: Simulated Malaxation Massage;
Mode 6: Simulated Beating Massage.
① “ ”button: Switch on/off
② “ ”button: Up/Down
③ “ ”button: left for turning down, and right for turning up
3. Button Instructions of Remote Control
A. Automatic Combination Mode 1 Massage;
B. 0-grade Massage Strength;
C. Medium-grade Heating;
D. Timing for 15 minutes
E. Red light on
To stop working, directly press “ ” button to switch it off.
Note:
① When operating remote control, the host will successfully receive the
signal as beep prompts; or else, please re-operate remote control.
② If there is no operation after switch on in 10s, the remote control will
enter slight light status to save battery capacity; and the screen will
light on normally as operating the remote control again.
4. Press “ ” button to switch on, the remote control will beep once, the
screen backlight will light up, and operating indicator of host will flash
slowly, including the following settings:
②
and insert Micro plug of USB connection into host charging port, then
the charging indicator flashes; after being fully charged, charging
indicator will keep on. If the built-in lithium battery level of massager
is enough, proceed with next step.
Insert USB into portable power or computer USB port (5V DC Voltage),
2. Put the Massager on, and make conducting strip closely cling to waist or
abdomen skin (do not use through clothing). Properly fit hook on both fixed
belts with loop and fairly adjust the tightness of fixed belts to make it not too
tight or too loose.
PG-2645红光版说明书 128铜版 印四色 尺寸： 骑马钉105x143mm PG-JS-2645-15-02-A 料号：307052241