User's Manual

User’s Manual Wireless USB Adapte r
Page 5
For Windows 7:
Once the wireless USB adapter be plugged into an USB port, the following message will
appear on screen.
The following installation procedures are similar to those of Windows XP. Please
refer to the installation steps for Windows XP.
4. Wireless Connection
For Windows XP:
1) After finishing driver installation, insert the USB adapter to Notebook or PC that supports
USB 2.0/1.1 interface.
Remarks: Make sure to connect the adapter to an USB port on your computer directly rather
than an USB hub. Although it might work when connecting with an USB hub, the likelihood of
configuration problems will be higher.
2) The system shows a wireless utility icon in the Windows system tray, which locates in the
bottom-right corner of your computer screen, and pops up a message that indicates a new
hardware is found and installed, something like this:
1) Before you begin, ensure WZC is enabled, by right-clicking on the Ralink icon in the
task bar in the bottom right corner of your screen.
In the menu that appears, select "Use Zero Configuration as Configuration Utility" to use
Windows' wireless management feature, Windows Zero Configuration (WZC) helps to
manage your Wireless Network Connection.
Should the service " Wireless Zero Configuration ( WZC)" be applied.