User's Manual

Table Of Contents

User

’

s Manual

Manual

Wireless

Wireless USB

USB

USB Adapte

Adapte

Page 4

Hardware

Hardware Installation

Installation

Installation Notes:

Notes:

1) Before installation, please check the power supply voltage first, to ensure normal power

supply is 5V;

2) Make sure the module pins correctly installed (VCC 5V; DATA +; DATA-; GND; TX

Control; EXTERNAL LED);

3) Make sure that the antenna does not allow users to replace or demolition;

4) Make ensure that the antenna placed natural vertical antenna installation;

5) Make ensure the module shield completeness;

6) Note that the wireless module installed from away the body 20cm.

Wireless

Wireless Connection

Connection

1. After finishing driver installation, insert the USB adapter to Notebook or PC that

supports USB 2.0/1.1 interface.

Remarks: Make sure to connect the adapter to an USB port on your computer

directly rather than an USB hub. Although it might work when connecting with an

USB hub, the likelihood of configuration problems will be higher.

2. The system shows a wireless utility icon in the Windows system tray, which locates in

the bottom-right corner of your computer screen, and pops up a message that indicates

a new hardware is found and installed, something like this:

Should the s ervice " Wireless Zero Configuration ( WZC) " be applied .