Parts and Accessories List

Trainer Mode:
The controller and the receiver have been successfully paired before shipment, and it can work without any
further code pairing. In the 1st set, the receiver is paired with the transmitter 001; in the 2nd set, the receiver
is paired with 001 and 002 of the transmitter respectively, and the receiver in the 3rd set is paired with the
001, 002, 003 of the transmitter respectively. You can switch between 001,002,003 by pressing the minus "-"
and plus "+" buttons. After selecting a channel, press the minus "-" and plus "+" buttons to change the
correction level (sound, vibration, shock). The fixed mode of the sound function is not adjustable, and the
vibration and electric shock functions have 3 levels (1-3 files) adjustable. The maximum remote control range
is about 300 meters (depending on the location and environment used, the distance will vary).
If you need to re-code, you can do it as follows:
Transmitter and receiver code pairing instructions:
First turn on the receiver, the red light is on. Turn on the fence controller, press the "mode" button to display
001 (if displayed otherwise it displays 1-100 etc.), press the "mode" button again until 001 is displayed. Then
press and hold the MODE button and the receiver's power button at the same time. The display screen of the
fence controller and the indicator light of the receiver will flash. After the code is successfully matched, the
transmitter display will be on and not flashing, and the red light of the receiver will change to a red light. At
this point, the receiver and fence are matched on channel 001. Do the same for the second item on 002 or the
third item on 003.
Test Methods:
1. Turn on the fence controller and receiver, then switch to wireless fence mode. Select a range and hold the
collar away from the fence controller. When you reach the limit of the range, the receiver will beep and the
red light will flash. This indicates that the receiver is in a warning area. If you walk further away, the receiver
will release the shock until you return to the warning and safety zone.
2. In trainer mode, press SOUND, VIBRATION or SHOCK button to test. Press the shock button, then you can
check whether the shock is illuminated with the matching test light.
Charge:
Fence Controller:
DC 5V, 3.7V lithium battery 2500mah. The LED will show "000" blinking. When the battery is low, please
charge it, it takes about 4-5 hours to fully charge (the red LED indicator is always on). Please use the included
charger for optimum performance.
receiver:
DC 5V 3.7V 400mah lithium battery. A full charge takes 2-3 hours (solid green light). If the receiver is not used
for 5 minutes, it will go to sleep and go to standby. A gentle shake or movement activates the collar instantly.