Shenzhen Neoway Technology WCDMA Module : User's Manual : Page 27

WM620 Hardware User Guide V1.1

LABEL OF THE END PRODUCT:

The final end product must be labeled in a visible area with the following" Contains TX FCC ID:

PJ7-1500 ". The FCC part 15.19 statement below has to also be available on the label: This

device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference and (2) this device must accept any

interference received, including interference that may cause undesired operation.

To comply with FCC regulations limiting both maximum RF output power and human exposure to RF radiation,

the maximum antenna gain including cable loss in a mobile-only exposure condition must not exceed 1dBi in

the cellular band and 1dBi in the PCS or WCDMA band.

A user manual with the end product must clearly indicate the operating requirements and conditions that must

be observed to ensure compliance with current FCC RF exposure guidelines.

The end product with an embedded WM620 Module may also need to pass the FCC Part 15 unintentional

emission testing requirements and be properly authorized per FCC Part 15.

Note: If this module is intended for use in a portable device, you are responsible for separate approval to

satisfy the SAR requirements of FCC Part 2.1093.