User's Manual

7
Note: the factory default process, please do not power outages.
Battery tips
The service life of the battery was designed for two years. The actual
capacity in alarm host has showed. When the battery is too low, the phone
APP will receive alarm sent by the host "battery is too low, please
replace the battery" push information. Replace the battery, please cut
off the linkage of the overflow water detectors and other equipment,
so as not to cause error alarm or linkage error operation of the
equipment.
Note:
Water detector equipped with batteries began to work, send information
to the mainframe, triggering other devices linkage.
Spilled water detector is used by batteries, battery, please according
to the methods specified so as not to cause explosion. When handling
the battery, please refer to the environment protection law.
Advanced configuration
1. Configuration delay shut down
After the shutdown command is issued, this configuration parameter can
be used to adjust the delay shut down automatically. This parameter can
be furnished with a value of 0 to 65535, where 0 means immediately issued
a shutdown command and 65535 refers to delay closing device after 65535
seconds
Function: open/close time.
Parameter number: 1.
Specification: 2 Byte
The available Settings: 0-65535 (in seconds).
The default Settings: 30 (in seconds)
2. The infrastructure level
When spilled water detector is triggered, water detector will be sent
contains a parameter value set command, the basis of the parameters of
the receiver will follow infrastructure orders value; , for example,
if a lamp module receives the basis set command, are included in the