User's Manual

4
Z - wave network added
Spilled water detection by Z - wave master equipment add water detector to the Z -
wave in the network。
1). Open water detectors, equipped with batteries, install the equipment in the main
control network within the scope of the equipment.
2.) sets the main control device to add learning model (please refer to the specific
master equipment operating instructions).
3) fast. Press the button three times to the code, LED lights flashing red light 5 times.
4). The main control device will detect water detector and add water detector to the Z -
wave in the network.
5). Waiting for the master device configuration water detectors
Deleted from the Z - wave network sensor
. Determine the power sensor has been connected.
2). Sets the main control device to remove learning model (please refer to the specific
master equipment operating instructions).
3) fast. Press the button three times to the code, LED lights flashing red light 5 times.
4). Waiting for the main control equipment removed from Z - wave network sensor.