User's Manual

Tips
 Please do not spray water on the power plug.
 The on and off of power plug can be switched remotely by mobile phone APP.
 The load connected with the power plug shouldn’t exceed 2500w to avoid
damaging of the power plug.
 Make sure of that power plug is in the gateway’s network.
The status of LED
1. When the power plug is on, LED light keeps being green.
2. When the
power plug is off, LED light keeps being out.
3. Quickly, triple click the code button ,add the
power plug to the Z-WAVE network or delete
PIR from Z-WAVE network , LED light flashes red and yellow for 5 times at the same time.
4. Press on the code button for 10 seconds, the PIR to restore factory settings, LED light flashes
red and yellow for 1 times at the same time.
Restore the Sensor (Power Plug) to Factory Default Settings
 Reset procedure will delete all information on the Z-Wave network and Z-Wave
controller or Z-Wave Gateway, and restore the sensor to factory default settings.
1. Plug the power plug in the socket.
2. Press and hold the button for 10 seconds, the LED light flashes.
3. Release the button.
 When the power plug is reset completely, The LED light will flash on and off
with dark alternately five times within 2 seconds.
NOTE
When the power plug is being restored factory settings, please make sure power
source is connected.
Associations
This has the effect that when the sensor is triggered, all devices associated with the
sensor will receive the relevant reports. Through an association the sensor may
control another Z-Wave network device, e.g. the alarm device, wall plug, lamp etc.
The Wall Plug provides two association groups:
Association group 1 is assigned to Plugs status - On/Off. Allows for receiving control
command from trigger devices whenever the Plug is turned On or Off.
Association group 2 reports relay's status to just one device, Z-Wave network's main
controller by default. It's not recommended to modify settings of this association
group.