User's Manual

Restore the Sensor (contact sensor) to Factory Default Settings

Reset will delete all information on the Z-Wave network or Z-Wave controller, and

restore the sensor to factory default settings.

1. Remove the cover of contact sensor main body.

2. Make sure the sensor is connected to power source.

3. Press and hold the reset button for 10 seconds, LED light will flash red for 1 time.

4. Release the button.

NOTE

When the Contact Sensor is being restored to factory default settings, please make

sure power source is connected.

Battery Usage Tips

Battery life of the contact sensor is approximately 10 years at factory default settings.

The current battery level is displayed in the gateway. Red battery icon means the

battery needs replaced. In order to avoid tamper detection, while replacing the battery,

please disconnect the association of the contact sensor with other devices.

Note

Contact sensor is battery powered. Using batteries other than specified may result in

explosion. Dispose of properly, please observe environmental protection rules.

Advanced Configuration

1. Configuring the OFF Delay

This configuration parameter that can be used to adjust the amount of delay before the

OFF command is transmitted. This parameter can be configured with the value of 0

through 65535, where 0 means send OFF command immediately and 65535 means

65535 seconds of delay.

Function: On/Off Duration.

Parameter Number: 1.

Parameter Size: 2 Byte

Available Settings：0-65535 (in seconds, each 1s).

Default Setting: 30 (s)

2. Basic Set Level

Basic Set Command will be sent where contains a value when the door/window is

opened or closed, the receiver will take it for consideration; for instance, if a lamp

module received the Basic Set Command of which value is decisive as to how bright