User Manual

Restore the Sensor (Siren alarm) to Factory Default Settings
Reset procedure will delete all information on the Z-Wave network or Z-Wave controller ,
and restore the sensor to factory default settings.
1. Remove the sensor’s cover.
2. Make sure the sensor is connected to power source.
3. Press the code button for 10 seconds, LED will flash red for 3 seconds.
4. Release the code button.
NOTE
When the siren alarm is being restored factory settings, please make sure power source is
connected.
Battery Usage Tips
Battery life of the siren alarm is approximately 1years at factory default settings. The
current battery level is displayed in the z-wave main controller. Red battery icon means
the battery needs replaced.
Note
Siren alarm is battery powered. Using batteries other than specified may result in
explosion. Dispose of properly, please observe environmental protection rules.