User Manual

Tips
 When install the siren alarm, please avoid the noisy places.
 Please install somewhere easy to find.
 Do not install in a ventilated position to affect the effect of the siren alarm.
 Do not install at a wet place to prevent the siren alarm from damaging.
 When the siren alarms, it would sound and the led would flash red lights.
 The siren alarm can be controlled remotely by mobile phone App.
 Association allows for direct communication between Z-Wave network devices.
Main controller does not take part in such communication. Using this mechanism,
siren alarm may communicate with other devices even when the main controller is
damaged.
The status of LED lights
1. when the
siren alarmis triggered, LED light flashes red for 12 seconds.
2. When the
siren alarm installs battery, LED light will flash red for 3 seconds.
3.
Quickly, triple click the code button ,add the siren alarmto the Z-WAVE network or delete
siren alarmfrom Z-WAVE network , LED light flashes red for 5 times.
4. Press on the code button for 10 seconds, the
siren alarm will be restored to factory default
settings, LED light flashes red for 3 seconds.
5. In the normal condition, the LED light keeps being out.
Associations
This has the effect that when the sensor is triggered, all devices associated with the sensor
will receive the relevant reports. Through an association the sensor may control another
Z-Wave network device, e.g. the alarm device, wall plug, lamp etc.
This Sensor supports two association groups.
Association group 1 is assigned to thesiren alarm status - ON/OFF.Allows for sending
controlled command to the associated device whenever the alarm siren is turned ON or
OFF.
Association group 2reports relay's status to just one device,Z-Wave network's main
controller by default.It's not recommended to modify settings of this association group.
NOTE
Association allows for direct communication between Z-Wave network devices. Main
controller does not take part in such communication.