User Manual

Including Sensor (Siren alarm) to Z-Wave Network
The siren alarm can be included to the Z-wave network by pressing on the code button.
1) Disassemble the siren alarm and insert the battery into the siren alarm. Make sure the
device is located within the direct range of the controller.
2) Set the controller into the learning mode (see main controller’s operating manual).
3) Quickly, triple click the code button, LED light will flash red.
4)Siren alarm will be detected and included in the Z-Wave network.
5) Wait for the main controller to configure the siren alarm.
Excluding Sensor (Siren alarm) from Z-Wave Network
1) Make sure the sensor is connected to power source.
2) Set the main controller into the learning mode (see main controller’soperating manual).
3) Quickly, triple click the code button, LED light will flash red for 5 times.
4) Wait for the main controller to delete the sensor.