User Manual

Q: Why the APP is unresponsive, or the lamp responds with delay after operation on the APP?
A: If so, check if your network is abnormal, or your phone storage is low.
Warranty
This product is covered with Miroco product and labor warranty for 12 months from the date of
its original purchase. If any problems occur, please contact the Miroco Customer Care Centre
via the contact information listed in this User Manual.
We can only provide after sales service for products that are sold by Miroco or Miroco
authorized retailers and distributors. If you have purchased your unit from a different place,
please contact your seller for return and warranty issues.
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.