User Manual

Notes:
The battery shall be charged for about 30min when it completely runs out of power, then the red lamp goes on.
Long pressing means to hold the multifunction key and not to release the key.
II. Mobile phone does not search the bluetooth headset
Possible causes:
The bluetooth headset is not under the pairing mode state when started;
Program of the bluetooth headset goes wrong;
Mobile phone bluetooth goes wrong;
Troubleshooting methods:
After the bluetooth headset is shut down, long press the multifunction key (namely the red light and blue light of the headset flashes alternately)
until to activate the bluetooth pairing;
Restore the factory settings of the bluetooth headset;
Re-start the mobile phone to delete all the pairing data saved in the mobile phone bluetooth; re-search the bluetooth
Notes:
After the bluetooth headset enters the pairing mode, it will be connected within 2min; after 2min, the headset will be automatically shut down;
When charged, the bluetooth headset will be automatically restored once; after charged, the mobile phone will be re-started and connected.
III. The speaker of the headset does not sound
Possible causes:
The volume of the mobile phone is not suitable, or the volume has been adjusted to minimum
The bluetooth headset is not perfectly connected with the mobile phone
The bluetooth headset is not within the limited working range
Troubleshooting methods:
Adjust on mobile phone
Re-pair and connect the bluetooth with the mobile phone
Remain the headset to be located within 10m of the mobile phone when the headset is used, without any barrier.
Notes:
Don’t carry out other operations when searching the bluetooth to prevent error of program.
To guarantee the best effect, please use the headset around the mobile phone.
IV. Don’t listen to a song after bluetooth is connected
Possible causes:
Bluetooth headset is monophonic
Settings of mobile phone bluetooth
The media volume of mobile phone is adjusted to minimum
Troubleshooting methods:
Music can be listened through the monophonic bluetooth headset only when the headset is paired with Nokia mobile phone; if the mobile phone
you used is not a Nokia mobile phone, music cannot be listened through the monophonic bluetooth
Inspect the bluetooth settings, and switch the sound path to hands-free device
Partial mobile phones need to enter the player for setting on two places: start the bluetooth function on the player, and click the connected
bluetooth device on the headset icon below
Individual mobile phone which is not provided with a complete stereo bluetooth headset does not have the function of listening music through
bluetooth. You can connect the bluetooth to other mobile phones to inspect whether this bluetooth headset is available
V. Headset cannot send words or word sound is small
Possible causes:
The bluetooth headset is too far away from mouth
The microphone hole of bluetooth is blocked or flooded
Troubleshooting methods:
The bluetooth headset can be normally used only when put on ears
Remove the blockages in the microphone hole or prevent water from entering the microphone hole
Notes:
The headset shall be put on head when bluetooth is used, and cannot be too far away.
The bluetooth headset shall be clean and cannot be flooded, or it is easy to damage.