User Manual

Make sure to use the headset around the mobile phone.
Bluetooth scope of work between your phone and headset line without blocking up to 10 meters. Beyond this distance, it
may cause quality decreasing or disconnection.
Know how to re-connect
1.After hearing the voice prompt of "Connection interrupted", please put the headset close to the mobile phone. It will
try to get re-connected within one min..
2.If your headset doesn't try to get re-connected, please press the multifunction key once more or re-connect it by
manual mode through the bluetooth device list of the mobile phone.
Photograph function
The bluetooth headset supports photograph function of mobile phone. It supports direct photo taking of iPhone and
most mobile phones with Android system. No APP photo functional software required. If you need to control the
function through the headset, please turn on the camera of the mobile phone, and double click Volume +.
Headset modes switching function settings
• If certain mobile phones can not be paired and connected, please try to switch the headset to single headset
mode: press Volume + and Volume - simultaneously for about 2s at pairing status and loose after hearing the prompt
；
tone "DEE". The headset will be under single bluetooth headset mode without photograph function If bluetooth
headset in pure mode to repeat this step all actions can be converted into headphones + self-timer mode, has a camera.
Reset
1. The headset will get reset once at charging. Namely, when the device is on, it will reset forcibly and shutdown at
charging.
Common problems and troubleshooting methods
．
I Bluetooth headset cannot be started
Possible causes:
The electric quantity of the battery of the bluetooth headset is low or the battery runs out of power
Time for pressing the key is not long enough
Troubleshooting methods:
Charge the bluetooth headset for more than 1 hour through a charger, and then try again.
The bluetooth headset is started by long pressing the multifunction key for 3s, and it accesses to pairing mode by long pressing the
multifunction key for more than 7s.