User's Manual

ManualsBrandsSHENZHEN MTN ELECTRONICS ManualsComputers & AccessoriesUSB WIRELESS ADAPTER

USB Wireless Adaptor User Manual

一、 Network Card Installation

Please follow the following steps to install your new wireless network card:

1. Insert the USB wireless network card into an empty USB2.0 port of your computer when computer

has power on. Never use force to insert the card, if you feel it’s stuck, flip the card over and try

again.

2. Insert device driver CD into the CDROM drive of your computer, double click the ‘Setup.exe’ icon

and run the ‘Setup.exe’ program.

3. Select the language that you are familiar with.

4. Click ‘OK’, then pop up the InstallShield Wizard

Summary of content (8 pages)

PAGE 1
USB Wireless Adaptor User Manual 一、 Network Card Installation Please follow the following steps to install your new wireless network card: 1. Insert the USB wireless network card into an empty USB2.0 port of your computer when computer has power on. Never use force to insert the card, if you feel it’s stuck, flip the card over and try again. 2. Insert device driver CD into the CDROM drive of your computer, double click the ‘Setup.exe’ icon and run the ‘Setup.exe’ program. 3.
PAGE 2
5. Click ‘Next’ , 6.
PAGE 3
7. Please wait while the installation procedure is running. Finally, click ‘Finish’ and restart your computer to finish the driver installation 二、 Connect to Wireless Access Point 1. After installation has finished, wireless configuration utility will be shown on the desktop of your computer, and it will try to connect to any unencrypted wireless access point automatically.
PAGE 4
2. Scan available wireless access point. Scan results will display in the ‘Available Network’ zone. If you can’t find the access point you wish to connect here, click the ‘Refresh’ button, until you can find your wireless access point. 3.
PAGE 5
4. If it’s an open wireless network system, you will be warned by this pop up dialogue 5. Click ‘OK’, and fill your information in the ‘Wireless network properties’, or just click ‘OK’. If the wireless access point has enabled encryption, you will have to input the WEP key or WPA preshared key in the form.
PAGE 6
. Then, you can find your wireless access point in the ‘Profile’, it will automatically connect to the access point every time you use your usb network card.
PAGE 7
. After you have connected to the wireless access point successfully, click the ‘General’ menu, you can get the detail information of connected access point, such as status、IP address、speed and so on. 8． Click the ‘Wi-Fi Protect Setup’ menu, by a simple setting allows you to secure connection to your wireless AP.
PAGE 8
NOTICE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications made to this equipment not expressly approved by SHENZHEN MTN ELECTRONICS CO., LTD. may void the FCC authorization to operate this equipment.