User Manual

2
Remote Battery Replacement:
If operation of the receiver units becomes erratic, it may be necessary to replace the CR2032 battery in the hand-held remote unit. To do this, first
remove the battery compartment cover. Press the tray release button on the back of the remote (refer to figure below). Next, remove the depleted
battery and discard according to local ordinances. Be sure the correctly install the new battery. Replace battery compartment cover and test by using
it to control the Indoor Remote Outlets.
Important: Install only new batteries of the same type in your product. Failure to insert batteries in the correct polarity, as indicated in the battery
compartment, may shorten the life of the batteries or cause batteries to leak. Do not mix old and new batteries. Do not mix Alkaline, Standard
(Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries. Danger of explosion if battery is incorrectly replaced.
Batteries should be recycled or disposed of as per state and local guidelines.
WARNING: This product contains a button battery. If swallowed, it could cause severe injury or death in just two hours. Seek medical attention
immediately.
 For best results, use type CR2032 batteries.
 Install only new batteries of the same type in your product.
 Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the batteries or
cause batteries to leak.
 Do not mix old and new batteries.
 Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries.
 Danger of explosion if battery is incorrectly replaced.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. such
modifications could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
1 Year
Limited Warranty: This product is warranted to the original purchaser only for a period of 1 year from the date of purchase for products
damaged due to defect in workmanship and materials. Proof of purchase is required to obtain warranty service. Warranty is for replacement only. No
service parts are available for these products. No other warranties are expressed or implied. Batteries are not covered under this warranty.
For warranty service, please contact Blackstone International Customer Service by phone: [phone] or email:
[e-mail]. A product may be submitted for warranty replacement by mailing the complete product along with proof of
purchase to:
Blackstone International, Ltd.
2018 Lord Baltimore Drive
Baltimore, MD 21244
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
The device has been evaluated to meet general RF exposure requirement.
This equipment complies with FCC's RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna(s) must not be co-
located or conjunction with any other antenna or transmitter.