Instruction Manual

phone
With wire .
The recording sound is too
small
Adjust the volume of the transmitter and receiver to the highest level
of transmission throughout the signal path without distortion
Get the best signal-to-noise ratio.
The microphone hole is blocked.
The sound is distorted
The volume between the transmitter and the receiver is too high,
reducing the volume between the transmitter and receiver, with the
goal of being in the entire signal path
Transfer the highest level without distortion for the best
signal-to-noise ratio.
The sound is noisy, the bag
Current sound, low noise,
pop sound, etc
Signal is disturbed 1. . Try switching channels
2. Try recording indoors with less RF interference indoors
3. Keep the transmitter at least 1 meter away from the receiver and
away from conductive objects such as metal and water Overhead
telephone lines, fluorescent lights, and metal fences can all interfere
with wireless microphones Turn off all computers and phones
nearby
The RF signal is weak 1. . Ensure that the line of sight between the
transmitter and the receiver antenna is clear 2. Your body, clothes,
and stage set can all be a hindrance
3. Make sure that the transmitter is within the operating distance of
the receiver
4. If there are obstacles, you may need to shorten the transmitter
and connection
The distance of the receiver
The sound is noisy, the bag
Current sound, low noise,
pop sound, etc
The input level of the camera, video recorder, or mixer is too high.
Lower the audio input level of the camera or recording device, lower
the audio output level on the receiver, and lower the low-key console
gain.
If there is no function on the device that is adjusted or set, and the
level is
Still high, adjust the volume of the transmitter or receiver
Transmitter
Pick-up mode
All point to the capacitor
antenna
FPC antenna
Stray suppression
-60dB
Audio input interface
3.5mm TRS interface
Reference deviation
±5kHz(-60dBV,1kHz input).
Distortion
≤0.5%
Sound delay
1ms
Battery type
750mAh lithium battery
Charge voltage
5V 500mA