Instruction Manual

ManualsBrandsShenzhen Minghan Technology ManualsMSShenzhen Minghan Technology M1 Wireless Microphone

User Manual

Model: M1

Summary of content (6 pages)

PAGE 1
User Manual Model: M1
PAGE 2
Pair method: 1, transmitter settings, short press "Settings key" to A/B,channel CH-XX, The setup is complete. to enter the menu selection, set transmitter 2, receiver settings, short press "Settings key" to enter the menu selection, set the A/B device with the same channel as the transmitter, set When complete, the receiver's A/B changes color, and the transmitter's power display takes effect.
PAGE 3
phone With wire . Adjust the volume of the transmitter and receiver to the highest level The recording sound is too of transmission throughout the signal path without distortion small Get the best signal-to-noise ratio. The microphone hole is blocked.
PAGE 4
Form factor 65*43*27mm weight 36g Receiver The number of channels 100 antenna FPC antenna Receive sensitivity -95dB Signal-to-noise ratio ≥90dB Reference deviation ±5kHz(-60dBV,1kHz input). Distortion ≤0.5% Frequency response 40Hz-18kHz(+/-3dB) Battery type 750mAh lithium battery Charge voltage 5V 500mA Form factor 65*43*27mm weight 36g Frequency Table Channel(CH). Frequency(MHz). Channel(CH). Frequency(MHz). 1 551.225 26 558.725 2 551.525 27 559.025 3 551.825 28 559.325 4 552.
PAGE 5
Channel(CH). Frequency(MHz). Channel(CH). Frequency(MHz). 1 573.325 26 580.825 2 573.625 27 581.125 3 573.925 28 581.425 4 574.225 29 581.725 5 574.525 30 582.025 6 574.825 31 582.325 7 575.125 32 582.625 8 575.425 33 582.925 9 575.725 34 583.225 10 576.025 35 583.525 11 576.325 36 583.825 12 576.625 37 584.125 13 576.925 38 584.425 14 577.225 39 584.725 15 577.525 40 585.025 16 577.825 41 585.325 17 578.125 42 585.625 18 578.425 43 585.925 19 578.725 44 586.225 20 579.025 45 586.525 21 579.325 46 586.
PAGE 6
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.