User's Manual

5.Troubleshooting/depannage/Fehlerbehebung/Risoluzione dei
problemi relativi/トラブルシューティング/solucion de problemas/
The power adapters may not be properly connected.
Ensure that the baby and parent units are on.
Adjust the monitor antenna to vertical position.
Make sure the baby and parent units arenot far away from each other.
Baby and parent units may not be properly paired.Follow pairing instructions.
Move the baby unit closer to parent unit.
Use of other 2.4GHz product,such as wireless networks(Wi-Fi routers),
Blueetooth systems, or microwave ovens,may cause interference with this product,
so keep the baby monitor at least 5ft(1.5m)away from these types of products
or turn them off if they appear to ba causing interference.
The baby or parent unitsmay ba too close to metal objects.
The battery power may be too low.
Restart the baby unit(unplug the power adapter from the wall outlet, wait for
approx 5 seconds and plug it back into the wall outlet).
Reset the parent unit by pressing the Reset button(16),located at the back of
the parent unit, under the stand.
The baby unit and parent unit may be too close to each other.Move them further
apart.
THE volume on the parent unit may be set too high.Lower the volume.
Volume setting on the parent unit may be too low.Increase the volume.
Battery power may be too low.Recharge the battery.
In a quiet environment,surrounding the parent unit,decrease the volume on your
parent unit to level 3 and below
In a loud environment,surrounding the parent unit,increase the volume to the
maximum level.
Automatic night vision mode may be on.Increase lighting around the camera to
force monitor out of night vision mode.
0323