Installation Instructions

Indoor Beacon_i10
All Rights Reserved by Minew | minew.com
5
TECHNICAL DOCUMENT
Item
Version
File Name
Date
Datasheet
V1.0
i10 Indoor Beacon Datasheet
12
nd
Sep, 2019
Instruction
V2.0
MiniBeacon Plus Configuration Instruction
5
th
May, 2018
SDK
V2.0
Both iOS and Android
18
th
May, 2018
FIRMWARE FLASH
1. J-LINK Programmer Kit;
2. Programming ports definition;
Please contact MINEW sales team to ask more related information if needed.
DECLARATION
The contents of this datasheet are subject to change without prior notice for further improvement.
Minew team reserves the right to explain all the terms of this datasheet.
CONTACT
Manufacturer: Shenzhen Minew Technologies Co., Ltd.
Phone: [phone]
Email: [e-mail]
Address:
3
rd
Floor, I Building, Gangzhilong Science Park,
QingLong Road, Longhua District,
Shenzhen 518109
China
https://www.minew.com
<END>
changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.