Product Info

TEL: [phone] EMAIL: [e-mail] URL: www.minewtech.com 4
E8 TagBeacon
MiniBeaconPlus Configuration Instruction
CONFIGURATION MODE
1. Settings Definition
SLOT: Each Beacon has 6 configurable SLOTs; it is from SLOT1 to SLOT6.
Connectable: Each Beacon has 2 different advertising statuses, connectable and disconnectable.
Only when the advertising status is connectable, the Beacon is configurable. But the
disconnectable advertising saves about 20% power consumption than connectable
advertising’s.
After completed the configuration, we strongly recommend setting the Beacon
disconnect not only lower battery power consumption but also better security
performance.
Update firmware (OTA: over-the-air):
- It’s not allowed to load unknown firmware into tag beacon;
- If there is a bug occurred unfortunately, the manufacturer is responsible to release the latest revised
firmware to help users to recover the bug by “Update firmware”;
Reset factory: It will recover beacon to factory settings and ignore all changes;
Poweroff: The Beacon will stop advertising and enter into sleeping mode after used “Poweroff”. But it
can be activated again by push button on the beacon. As Beacon doesn’t have a push
button, we are strongly opposed to use “Poweroff”.
Modify password: Change to a new password by “Modify password”.
Remove password: Removing the password if someone forgot it and then set a new password by “Add
password”.
Manufacture info & Feature info: It’s not changeable by users.
2. SLOT Configuration
Each SLOT is independent and configurable. The following parameters can be configured. The users can
configure each SLOT’s Frame Type, Adv. Content, Base params and Trigger by themselves via
BeaconSET+.
2.1 Frame Type
Actually, the frame type is the format of advertising data packet. Each Beacon has below total 7
different frame types: UID, iBeacon, URL, Acc. Sensor, TLM, Info and NO DATA, see image 8;