User Manual

This device and its antenna must not be located or operating in conjunction with any other
antennaandtransmitter.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interferencereceived,includinginterferencethatmaycause undesired
operation.
Changesor modificationsnotexpresslyapprovedby theparty responsibleforcompliance could
voidtheuser’sauthoritytooperatetheequipment.
NOTE: This equipmenthas beentested and found to complywith thelimits for aClass B digital
device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
usesandcanradiateradiofrequencyenergyand,ifnotinstalledandusedinaccordancewiththe
instructions, may cause harmful interference to radio communications.
 However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
causeharmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturning
the equipment off and on, the user is encouraged to try to correct the interference by one or
moreofthefollowingmeasures:
‐Reorientorrelocatethereceivingantenna.
‐Increasetheseparationbetweentheequipmentandreceiver.
‐Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
‐Consultthedealeroranexperiencedradio/TVtechnicianforhelpimportantannouncement

LABELOFTHEENDPRODUCT:
The final end product must be labeled in a visible area with the following" Contains FCC ID:
ZLZTDBTSE"andContainsIC:9726A‐TDBTSE.TheFCCpart15.19statementbelowhastoalsobe
availableonthelabel: ThisdevicecomplieswithPart15of
FCCrules.Operationissubjecttothe
followingtwoconditions: (1) thisdevice may notcauseharmful interferenceand (2)this device
must accept any interference received, including interference that may cause undesired
operation.Ausermanualwiththeendproductmustclearlyindicatetheoperatingrequirements
and conditions that
must be observed to ensure compliance with current FCC RF exposure
guidelines.TheendproductwithanembeddedPanlinkIIModulemayalsoneedtopassthe
FCCPart15unintentionalemissiontesting requirements and be properly authorized
perFCCPart15.
TocomplywithFCCregulationslimitingbothmaximumRF
outputpowerandhumanexposureto
RFradiation,themaximumantennagainincludingcablelossingeneralexposureconditionmust
notexceed3.5dBi.
ThemodularusedRP‐SMAantennaconnectorandtested3antennas,
Antenna AntennaType MaximumAntennaGain
Antenna1 FPC 2dBi
Antenna2 Dipole 3.5dBi
Antenna3 FPC 1dBi
If end users use others antennas except stated, end‐users need test radiated emission, RF
exposurerefertoFCCC2PCrules.