User Manual

ManualsBrandsShenzhen Mindray BIO-Medical electronics ManualsElectronicsBluetooth Low Energy Module

1.1 Gene



Panlink II module consists of a BT module, crystal and antenna connector. This module can

change UART signal to wireless signal using Bluetooth low energy technology. This module uses

external antenna via a Antenna connector.

Panlink II communication type is piconet, which means Panlink II transfers data to another



Panklink(one is master, the other one is salve).



When transfering data from master to slave, data was given to master by UART. Then

master Panlink II controls signal, frames, radiation power and transmits them via the antenna to

slave Panlink II. Slave Panlink II get RF signal via the antenna and resolve it to data.

When transfering data from slave to master, data was given to master by UART. Then slave

Panlink II controls signal, frames, radiation power and transmits them via the antenna to master

Panlink II. Master Panlink II get RF signal via the antenna and resolve it to data.

And there are some requisition for end-user as below,



圃

The module is limited to OEM installation ONLY;



圃

The OEM integrators is responsible for ensuring that end-user has no manual

instructions to remove or install module;

圃

The module is limited to installation in mobile or fixed application



圃

The separate approval is required for all other operating configurations, including

portable configuration with respect to Part 2.1093 and different antenna configurations;

圃

The host manufacturer is responsible for ensuring that after the module is installed and



operational the host continues to be compliant with the Part 15B unintentional radiator

requirements

Summary of content (6 pages)

PAGE 1
.1 General Decription Panlink II module consists of a BT module, crystal and antenna connector. This module can change UART signal to wireless signal using Bluetooth low energy technology. This module uses external antenna via a Antenna connector. Panlink II communication type is piconet, which means Panlink II transfers data to another Panklink(one is master, the other one is salve). When transfering data from master to slave, data was given to master by UART.
PAGE 2
1.2 Block diagram 1.3 Interface and pin definition No.
PAGE 3
23 RF Connector RF Connect to antenna 1.4 Operation specification ABSOLUTE MAXIMUM RATINGS Over operating room temperature range (unless otherwise noted) Item VALUE UNIT Supply voltage range -0.3 to 3.9 V Voltage range to any of digital -0.3 to VDD + 0.3, <3.9 V pins Storage temperature range ℃ -40 to +85 RECOMMENDED OPERATING CONDITIONS Over operating room temperature range (unless otherwise noted) Item MIN Supply voltage NOM MAX UNIT 2.4 3.
PAGE 4
PAGE 5
This device and its antenna must not be located or operating in conjunction with any other antenna and transmitter. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 6
‐ English: This device complies with Industry Canada licence‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES‐3 (B)/NMB‐3(B). ‐ French: Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.