User's Manual

connected.
-Consult the dealer or an experienced radio/TV technician for help Important announcement
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following" Contains FCC
ID: ZLZTDBTFE ". The FCC part 15.19 statement below has to also be available on the
label: This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
To comply with FCC regulations limiting both maximum RF output power and human exposure to
RF radiation, the maximum antenna gain including cable loss in a mobile-only exposure condition
must not exceed -1dBi.
A user manual with the end product must clearly indicate the operating requirements and conditions
that must be observed to ensure compliance with current FCC RF exposure guidelines.
The end product with an embedded Pan link Module may also need to pass the FCC Part 15
unintentional emission testing requirements and be properly authorized per FCC Part 15.
a. The module is limited to OEM installation ONLY;
b. The OEM integrators is responsible for ensuring that end-user has no manual instructions to
remove or install module;
c. The module is limited to installation in mobile or fixed application
d. The separate approval is required for all other operating configurations, including portable
configuration with respect to Part 2.1093 and different antenna configurations;
e. The host manufacturer is responsible for ensuring that after the module is installed and
operational the host continues to be compliant with the Part 15B unintentional radiator requirements.