User's Manual

Introduction Patient Management
5 - 2 TMS60 Operator’s Manual
5.1 Introduction
The chapter describes how to admit a patient, change the patient size, enter and exit the
Standby mode, and discharge the patient.
5.2 Admitting a Patient
When admitting a TM80 for the first time, the device must be admitted to the system
through the CS. For details about admitting a patient through the CS, refer to the
BeneVision Central Station Operator’s Manual (P/N 046-005011-00).
After first admitting the device to the CS, you can directly admit the new patient at the
TD60 by discharging the current patient, and then pressing the key to admit a new
patient. Refer to "Discharging the Patient" on page 5 - 4 for details.
5.3 Changing the Patient Category
1. In the main menu, tap [Patient Info].
2. In the [Patient Info] menu, tap [Patient Category] to select the desired patient
category.
The screen displays the “Are you sure you want to change patient category?” mes-
sage.
3. Select [Ye s ] to confirm that the patient category is changed.
The selected patient category displays to the right of [Patient Category].
4. Tap the icon to exit the [Patient Info] menu.
NOTE
• Ensure the patient category selection is appropriate for the patient
before monitoring begins.
NOTE
• The patient category can only be changed at the TD60.
• Adjusting patient category restores the TD60 to the default (preset) set-
tings but does not clear patient information or data.