User's Manual

Skylle 1550 User Manual 20181107V2 |30
26 / 31
2. AREA DRAWING
Method 1
1. Click the “Draw” button;
2. Double-click the position you want to select on
the map, then add the point of the polygon you
want to scan;
3. When the number of added points is more than
three, right click to finish drawing;
4. Click “Finish Draw” or click the right mouse
button on the map to complete the area drawing.
Method 2
Draw an area in Google Earth and save it as a .kml file.
Then click the button loaded from KML in the
drawing function, import the file into the ground
station software to complete the drawing.
3. AREA ADJUSTMENT (selective use as needed)
1. Click the “Adjust” button, the current area scan
area is in the adjustment state;
2. Left mouse click on one of the points, then
hold click and drag the current point to the
position you want to modify;
3. Complete the adjustment by clicking the
“Finish Adjustment” or by right-clicking on the
map area.
4. PATH ADJUSTMENT (selective use as needed)
Click the “Transpose” button to control the starting
point and flight order of the scanned area;
When the drawing is completed, long press the
screen to click the task and send to the drone. Then
power on the drone. When the drone successfully
takes off, switch to the route mode, then the
aircraft can automatically perform the task.
Selecting the scan area Scanning area determination
5. WHEN THE SONY A7R IS SELECTED
Set the grid angle and the turnaround area.
Drawing and adjusting are the same as using a
custom grid camera.
Using the MMC OPE camera (Figure 3.23), set the
grid angle and turnaround area as needed. The
drawing and adjustment methods are the same
as the custom grid camera. The task is sent to the
drone after the drawing is completed.
Sony A7R camera editing interface
PO5 Oblique Photography editing interface
MMC OPE