User's Manual
Skylle 1550 User Manual 20181107V2
|30
13 / 31
The antenna can be rotated 90 degrees and angled 90 degrees.
Forcing the antenna further than this can damage it. The antenna is not
removable.
Monitor LED Display
The status of the transmitter is displayed by LED at the bottom left and
right sides of the “T14SG” logo.
LED (Left)
Displays the “non-default condition” warning.
Blinking: Power switch is turned ON when any condition switch is turned
ON.
LED (Right):
Displays the state of radio frequency transmission.
•
OFFRadio waves are in OFF state.
•
ONRadio waves are being transmitted.
•
Blinking Range check mode.
Switch (SA-SH):
SA : 3 position; Alternate; Short lever
SB : 3 position; Alternate; Long lever
SC : 3 position; Alternate; Long lever
SD : 3 position; Alternate; Short lever
SE : 3 position; Alternate; Short lever
SF : 2 position; Alternate; Long lever
SG : 3 position; Alternate; Short lever
SH : 2 position; Momentary; Long lever
*You can choose switch and set the ON/OFF – direction in the setting screen of the mixing functions.
Digital Trim
Digital Trim T1, T2, T3 and T4
:
This transmitter is equipped with four (4) digital trims. Each time you press a trim button, the trim position moves one step. If you
continue pressing it, the trim position starts to move faster. In addition, when the trim position returns to ~ monitor trim positions by
referencing the LCD screen.
On the home screen on the T1-T4 setting screen within the linkage menu.
Note: The trim positions you have set will be stored in the non-volatile memory and will remain there.
Volume
The volume LD and RD knobs allow for analog input.
* The T14SG transmitter beeps when the volume knob reaches the center
position.
LS (Left), RS (right)
:
The slide lever LS and RS offer analog input.
*
The T14SG transmitter beeps when the lever comes to the center.
Movement of cursor, value input or mode selection
Movement of the cursor on the menu screen and movement of the cursor among items on a setup screen can be controlled by
scrolling your ~ also go to the next page, if there is a next page.