Quick Start Guide

3 / 7
1.1 Functions and operation instructions of each component
LED brightness: under the working state, turn to adjust the brightness of LED light
source.
Micro USB charging: when the power of the device is low, connect a charger to
charge the device. It is not recommended to use the device during charging (it will
reduce the service life of the device battery).
Indicator light: This hole indicates the working state of the equipment. Under the
working state, the blue light is always on. When the USB is plugged in, the red light
will be on, and when the USB is fully charged, the red light will be off.
Reset: when the equipment is stuck or cannot be shut down abnormally during
operation, use a thin pointed object to stamp the reset button to shut down.
On / off: press this key for 2 seconds to turn on the machine, and press this key for 2
seconds to turn off the machine in the working state.
Photo / video recording: under the working state of the device, short press can take
photos and automatically save photos, long press 2 seconds to enter the recording
mode, then long press 2 seconds to exit the recording mode and save the recorded
video, which can be viewed in the APP folder or in your iOS/Android device photo
album.
Focus adjustment roller: under the working state of the equipment, rotate this roller
to adjust the focus and focus the shooting object.
LED light source: brightness level knob can adjust its brightness.
2. Use Wifi digital microscope on your IOS/Android device
Reset hole
5
On / off
6
Take a picture / video
7
Focal length adjusting roller
8
8.
Light emitting diode