Specifications

Microwave Module MIC01-5GH01 Version: A1
Shenzhen Merrytek Technology Co.,Ltd
Add: 2
nd
and 3
rd
floor, NO.3 Building, 380 Xiangshan Avenue, Luotian, Yanluo, Baoan, Shenzhen, 518127,China
Tel: [phone] Fax: [phone] Website: www.merrytek.com
Page
7
of
8
220uF at the VCC of input power.
7) The product should be installed as far away as possible from scenes like large metal equipment, pipes, air
conditioning outlets, exhaust vents, smoke exhausters, to avoid the equipment vibration.
8) The microwave module should be kept away from the AC power supply, and should be far away from the
rectifier bridge, transformer, switch tube and other high-power devices of power supply to prevent
high-frequency signals from interfering with the normal operation of the microwave module.
9) Interface pin header is not included by default.
10) Specifications and parameters may be optimized without prior notice.
11) During product design, please keep high current flow off the antenna surface of the microwave module
and its nearby, make sure that transformers or high-frequency components are in the distance greater than
10mm, and should be 5mm lower than the height of the microwave module, as shown in the figure below:
12) When wiring, the antenna surface and the component surface of the back must not be blocked by wires
or large current flows, so as not to affect the normal operation of the sensor, as shown in the figure below: