Specifications

Microwave Module MIC01-5GH01 Version: A1
Shenzhen Merrytek Technology Co.,Ltd
Add: 2
nd
and 3
rd
floor, NO.3 Building, 380 Xiangshan Avenue, Luotian, Yanluo, Baoan, Shenzhen, 518127,China
Tel: [phone] Fax: [phone] Website: www.merrytek.com
Page
5
of
8
8. Typical application circuit and parameter configuration
Declaration: F1, F2, F3 are pins for hold time setting, F4 is for detection sensitivity, and F5 is a pin to switch
the daylight sensor, details are specified in the below sheet. If only fixed parameter are needed, the DIP
switch in the above figure can be replaced with 0R resistance.
S1(F1)、S2(F2)、S3(F3) Configuration Sheet
Number
Scene Number
S1(F1)、S2(F2)、S3(F3) Status
The hold time output by O pin
1
QS1
S1 close, S2 close, S3 close
60min
2
QS2
S1 close, S2 close, S3 open
30min
3
QS3
S1 close, S2 open, S3 close
10min
4
QS4
S1 close, S2 open, S3 open
5min
5
QS5
S1 open, S2 close, S3 close
3min
6
QS6
S1 open, S2 close, S3 open
1min
7
QS7
S1 open, S2 open, S3 close
30S
8
QS8
S1 open, S2 open, S3 open
2S (Factory tested gear)