Specifications

Microwave motion sensor MC606V Version: A2
Shenzhen Merrytek Technology Co.,Ltd
Add: 2
nd
and 3
rd
floor, NO.3 Building, 380 Xiangshan Avenue, Luotian, Yanluo, Baoan, Shenzhen, 518127,China
Tel: +86 (0)755-2305 7253 Fax: +86 (0)755-2786 3012 Website: www.merrytek.com
Page
8
of
8
11. Application notice
1. The sensor should be installed by a qualified electrician. And ensure that the electricity supply is switched
off before installing or servicing the product.
2. Installation inside a glass or plastic housing will result in a reduction of detection sensitivity. Expect a
reduction of approximately 20% for every 3mm of thickness.
3. Detection area will be affected by speed of motion, height of installation and volume of moving object.
4. Daylight sensor was tested on sunny environment with no lampshade
5. Sensors settings may need to be adjusted to match installation site, please follow below instructions or
contact manufacturer.
6. The sensor is designed for indoor use only. Outdoor use for a long time may reduce the waterproof effects.
The raining or wind blowing may trigger the microwave sensor even if without human motion when outdoor
use.
7. The distance between any two sensors should be at least 3m to avoid interference with each other.
8. When the microwave sensor is installed in a metal lighting fixture or space with large reflector, for example
a warehouse with metal roof, the microwave will be reflected and cause the lights permanently illuminated
even if without motion signal. Please reduce the detection area (sensitivity) to solve the problems, or contact
the microwave sensor manufacturer to provide technical support.
9. Make sure the sensor not close to or be blocked by high density material, such as metal, glass, concrete
walls etc. The materials will reduce or block microwave and cause false trigger.
10. Make sure there are no fans or other vibrating objects in installation area. The movements will trigger
sensor as well.