User's Manual

Model:MC077V RC
MC077V RC
Automatic switching or dimming when used in combination
with 1-10V dimmable LED drivers or ballasts.
Built-in daylight sensor.
Compact size makes it suitable to fix within most luminaires.
Detection area, time delay and daylight threshold can be
precisely set via DIP switch.
Wide detection area, range up to 7m in diameter.
Support higher mounting height 4m Max.
Optional surface mounting and base mounting
GENERAL GUIDELINES FOR INSTALLATION
1, The sensor should be installed by a qualified electrician. And ensure that the
electricity supply is switched off before installing or servicing the product.
2, The sensor should not be modified in any way. Any modifications made for
this product will immediately invalidate any warranties issued.
3, The company does not accept responsibility for any consequences resulting
from unauthorized modification of the product.
4, The sensor should be connected to a stable power supply of 120/277Vac
50Hz/60Hz.
5, Microwaves cannot pass through metal or brick walls if thicker than 20cm.
They will pass through thinner walls but there will be some attenuation.
6, Installation inside a glass or plastic housing will result in a reduction of
detection sensitivity. Expect a reduction of approximately 20% for every 3mm
of thickness.
INSTALLATION & WIRING
The sensor has 6-position terminal block as Pic 1:
L(Phase) N(Neutral) L' (Switched phase / control)
1-10V (Connected to 1-10V interface)
The sensor is designed for installation at 4m Max in height.
1) FOR ON/OFF FUNCTION :
Connect to normal control gears (normal LED drivers or ballasts), the wiring as
following:
2) FOR DIMMING FUNCTION :
Connect to 1-10V dimmable control gears (1-10V LED drivers or ballasts),
the wiring as following:
WIRING SCHEME
MICROWAVE MOTION SENSOR USER’S MANUAL
MI190523A0
Operating voltage 120/277Vac, 50Hz/60Hz
IP rating IP20
Operating temperature -25°C~60°C
Motion detection 0.5~3m/s
Mounting height 4m Max.
Stand-by dimming level 25% / 35% / 50%
Daylight sensor 5lux / 25lux /50lux / 100lux / Disable
Hold time 5s / 5min / 10min / 20min / 30min
Detection sensitivity 25% / 50% / 75% / 100%
Detection zone Max.(D x H): 7m x 4m
Power consumption ≤0.5W(standby), <1W(operation)
Transmitting power 0.5mW Max.
HF system 5.8GHz±75MHz, ISM wave band
Rated capacitive load 120Vac 50/60Hz 2A Ballast
277Vac 50/60Hz 2A Ballast
Detection angle 150°
Pic1
Stand-by period 0s / 5min / 15min / +
∞
Set by remote 0s/10s/1min/3min/5min/10min/30min/+
∞
Set by remote 5lux/15lux/30lux/50lux/100lux/150lux/Disable
Set by remote 5s/30s/1min/3min/5min/10min/20min/30min
L
N
Control
gear
L
N
Control
gear
L
N
Control
gear
L
N
Max. 400W
(2A)
L
N
LED
Driver
-
++
-
1-10V LED
L
N
E489 677