User's Manual

产品 手册
User manual
6.9 Advanced setting options
Without voice prompt, programme address and the corresponding options
as below table.
59 Sensor recovery 5
60 Sensor loss 5
61 System low battery 5
62 System AC loss 5
63 System AC recovery 5
64 Zone bypass 5
65 Telephone line fault 5
66 Periodic test report 5
67 Wireless zone loop trouble 0
68 Wireless zone loop recovery 0
69 System battery recovery 0
70 Communication trouble 0
71 Bypass cancel 0
72 Alarm cancel 0
73 Disarm 0
74 Armed stay 0
75 Armed 0
76 Panel programming changed 0
77 System alarm failure 5
78 Telephone line recovery 4
79 Communication recovery 4
01 GPRS enable and disable
02 Set sever IP address
03 Set sever port
04 Set user ID
05 Set user password
06 GSM SMS language
07 Delay zone tone source options
08 Handshake tone input signal
intensity
09 DTMF output signal intensity
10 Set LCD standby brightness
11 Alarm event retain time
50 System 00 zone 7
51 Delay zone 7
52 Perimeter zone 7
53 Interior zone 7
54 24 Hour zone 7
55 Emergency zone 7
56 Fire zone 7
57 Tamper zone 7
58 Sensor low battery 5
Programming address 50-79 are correspond to the options for the alarm
content, the right of data are factory default.
Set alarm data as below:
0. Do not send any information
1.Only send SMS.
2.Only telephone line
3.SMS+telephone line
4.Only upload to CMS
5.Upload to CMS+SMS
6.Upload to CMS+telephone line
7.Upload to CMS+SMS+telephone line
34