User's Manual

2.4 Configure the tag’s sending time interval and sending
power
Configure tag parameter is only valid to Read&Write tags(passive), Readonly(Active) tag can not be configured
“Tag” bar: fill the original tag ID, Click “Search” will show the current parameters
Setting Tag‟s sending time interval: Select a proper time you need
Setting tag‟s sending power: Select a proper power
Send mode: Readonly or Read&Write
Note:Here you should pay attention to it ,if the tag is changed to be a Readonly tag, means it
will be change to an active tag, then you can not configure the parameters any more
Fill the original ID in the “Tag” bar, then select a time interval and a sending power, time interval means every 1s
or 2s the tag send a signal to reader, Power means the tags antenna‟s sending power, it can adjust the tags and
reader‟s identify range, then Click “Set”, if success it will return a success information.
Tag current parameter
Query success