User's Manual

Com connection: If you use com port to connect the reader with PC, select the right com port and a proper
communication baudrate (from 9600bps to 115200bps supportable), then click connect.
Ethernet connection: If you use RJ45 to establish the connection, fill the reader‟s IP address and port No in the
software, then click connect. Here you can connect it to PC via a switch. Pay attention to the reader‟s IP address
and the PC „s IP should be stayed in the same network segment.
Via the demo software you can query the reader’s IP and the set a new IP for reader.
Click “Search IP” to query the pre-configured IP address, see following:
This reader support com port configure the IP address, after configure success, you should reset the reader, then
the IP address can be valid to use.
Ethernet connection
Ethernet connection success, see following:
Com connect success