User's Manual

7. The red light keeping on when charging and light off
when earphone battery full.
8.When the power of the wa
t
ch is lower than 10%, the
earphones will not be charged. The earphones will
automatically turn on and connect the phone, and the
phone will display the connected status. (Please charge
the watch in time)
Attention! After using the earphone, please clean it and then
put it in the charging case. Please make sure that the
charging position on the earphone is clean and free of water,
sweat and dirt. To prevent abnormal charging or oxidation,
causing damage to the product and affecting use!
1. Charge:When the battery is too low, please timely
charge can effectively protect the battery life.
2.To avoid overheating of the equipment and cause
accidents, do not charge device while it is in an
environment above 50℃.
3. The device uses the built-in battery, to avoid damage to
the device, do not disassemble by yourself.
4. Do not make the device subjected to violent impact,
puncture and extrusion to prevent damage and rupture of
the battery; If the battery ruptured, please avoid contact
with eyes and skin. Please do not rub the contact part if
the battery contacted with the skin, rinse immediat
ely
with water and send to the doctor.
5. The measured data of this equipment are all reference
data, do not use as a medical device.
6. Put the earphone into the watch, and earphone will
automatically shut down and charge, take the earphone
out of the watch, it will automatically power on.