User Manual

2
Product Installation Instruction
AA
A
A
B B
D
C
C
D
A.Screw hole
B.Square outlet fixing screw
hole
C.Rectangleoutlet fixing
screw hole
D.Round bracket nut fixing
hole
E.Green Power socket
G.LAN Socket(Option)
A. (For no Outlet):Mark 4 A position points with a pen>Drill holes above marked points>Tap in 4 plastic
plugs> Lock 4 screws to fix the Wall Mouting Plate on the wall.
B. (For Square Outlet):Use 2 M4 screw to aim the outlet screw hole >lock the screw to fix the Wall
Mouting Plate and square Outlet .
C. (For Rectangle Outlet):Use 2 M4 screw to aim then outlet screw hole> lock the screw to fix the Wall
Mouting Plate and Rectangle Outlet .
D.(For Circular Outlet): First lock 2 long M4 screws on the circular bracket >use two short M4 screws fix
the circular bracket to outlet>place the Cover Pad on the bracket >Insert 2 bracket screws after aligning the
Plate holes > lock the nut to finish Wall Mouting Plate fixed to the circular bracket.
E
F
LAN
3. Align the Housing back Rectangle gap
with the Wall Mouting Plate
> press the Housing close to the Plate
>lock the up & bottom lock screws to
complete the installation.
Recommend installation height is 2.5M:
Distance from the ground to the bottom of
the product.
For Circular Outlet (option): as shown in the
figure above
first lock two long M4 screws on the circular
bracket.
>use 2 short M4 screws to fix the bracket on the
outlet.
> place Cover Pad between bracket and plate
>insert two screws into the screw holes of the
plate.
>lock two spare nuts at D position to fix the plate
& circular bracket.
1.Hold the side of Wall Mouting Plate by hand, slightly rock up and down,
then pull out the Wall Mouting Plate
2.First made the power cable via to the F hole> connect the cable to green
power socket (E position)> use screwdriver to fix the cable tight>according to
the installation environment>select one installation mode (A to D) to fix the Wall
Mouting Plate on the wall.
Top Lock Screw
Bottom Lock Screw Hole
M4 Screw
M4 Screw
G
Cover Pad