User's Manual

27
5.7 FAQs on MMS Function
x I set up a new receiving phone number. But the MMS pictures are
still being sent to the old number. What should I do?
Switch the camera OFF. Wait for at least two minutes. Then
switch it ON.
Or, switch the camera OFF. Take one battery out of the MMS-
module battery box, and then reinstall it.
x Why did it take so long to receive the MMS pictures / why didn’t I
receive any MMS pictures?
The signal was too weak. Or the batteries ran out.
x I programmed the camera to constantly take pictures. But some
pictures were not sent to my phone. How?
The Ltl-5310M series camera is designed to constantly send
MMS pictures to the recipient’s phone. However, if the signal is
too weak, it may not work stably.
x Why did I receive some pictures with partial image, and some with
“red X”?
The camera was in motion when sending pictures. Or the signal
was unstable.
x I was pretty sure the battery was quite low. But I didn’t get any text
alert. Why?
The camera “assumes” you install new batteries when you start
the camera. It tracks the usage of the batteries and texts you
when the power is low. However, if you replace the present
batteries with some “used” ones in a point before receiving a text
alert, the camera will get “confused” and not send a text alert
later on.