User's Manual

The Timer function is OFF. If you have the Timer ON, make sure you are

in the specified time period when expecting incoming MMS pictures.

Make sure MMS Status is not set OFF or SMS.

The setting

is “0”, or the daily limit has not been reached. If the daily limit has been

reached, you can reset that number on your computer or on the TFT

display. Then the daily limit starts to count from One.

The camera is stationary while sending MMS pictures.

3.7View Local MNPO name and Signal Strength on TFT Display

You can find your local Mobile Phone Network Operator’s name and the

signal strength on the TFT display on the camera, just like you can see the

information on a regular cell phone.

Install the SIM card and 8 AA batteries. Make sure the camera is switched

in OFF position. Attach the MMS-module battery box to the camera. Switch

to the TEST position. If you like, you can connect the camera to a TV using

provided TV AV IN cable. Wait for 1 minute and then you will be able to view

the MPNO name and the signal strength on the TV. If you don’t have an

access to a TV, wait for 1 minute and detach the battery box. Then you can

view the information on the TFT display.

When appear Mobile operators trademark buzzer will be issued two sound "di, di".

There are three bars indicating the signal strength. To allow the MMS

function to perform, at least one bar is required.

If a code, instead of the MPNO information, shows on the screen, it

indicates something is wrong, missing, or going on. Specifically,

SIM: No SIM card or installed incorrectly.

CSQ: No signals.