User's Manual

Thermal Image Scope User Manual
vi
Safety Instruction
These instructions are intended to ensure that user can use the product correctly to avoid danger
or property loss.
Laws and Regulations
● Use of the product must be in strict compliance with the local electrical safety regulations.
Transportation
● Keep the device in original or similar packaging while transporting it.
● Keep all wrappers after unpacking them for future use. In case of any failure occurred, you need
to return the device to the factory with the original wrapper. Transportation without the
original wrapper may result in damage on the device and the company shall not take any
responsibilities.
● DO NOT drop the product or subject it to physical shock. Keep the device away from magnetic
interference.
Power Supply
● Please purchase the charger by yourself. Input voltage should meet the Limited Power Source (5
VDC to 12 VDC) according to the IEC61010-1 standard. Please refer to technical specifications
for detailed information.
● Use the power adapter provided by qualified manufacturer. Refer to the product specification
for detailed power requirements.
● Make sure the plug is properly connected to the power socket.
● DO NOT connect multiple devices to one power adapter, to avoid over-heating or fire hazards
caused by overload.
Battery
● Improper use or replacement of the battery may result in explosion hazard. Replace with the
same or equivalent type only.
● The built-in battery type is MS621R, and the battery size should be 6.7 mm × 2.1 mm. The rated
voltage and capacity are 3 VDC/3mA.
● The external removable battery type is CR123A, and the rated voltage and capacity are 3.7 VDC
and 1700 mAh. Dispose of used batteries in conformance with the instructions provided by the
battery manufacturer.
● The rated voltage and capacity of the battery pack are 7.4 VDC and 7300 mAh.
● Use the battery provided by a qualified manufacturer. Refer to the product specification for
detailed battery requirements.
● Confirm there is no flammable material within 2 m of the charger during charging.
● DO NOT place the battery near heating or fire source. Avoid direct sunlight.
● DO NOT place the battery in the reach of children.
● This equipment is not suitable for use in locations where children are likely to be present.
● Do not dispose of the battery into fire or a hot oven, or mechanically crush or cut the battery,
which may result in an explosion.