User's Manual

Thermal Image Scope User Manual
19
Chapter 4 Crosshair Settings
4.1 Select Crosshair Memory
If different users use the same device, the users can configure and save the crosshair settings in
their respective crosshair memory group.
Before You Start
Press and to enable crosshair in the live view interface.
Steps
Steps
1. Hold to go to the menu.
2. Press or to select (Crosshair Memory), and press to enter the setting
interface.
3. Press or to switch the crosshair memory group from A to E.
4. Hold to save settings and exit.
Note
There are 5 crosshair memory groups in total, and you can configure 7 crosshairs in each crosshair
memory group.
4.2 Set Crosshair
You can select a crosshair in the crosshair memory group, and set parameters such as type, color,
and position for the crosshair.
Before You Start
Press and to enable crosshair in the live view interface.
Steps
1. Hold to go to the menu.
2. Press or to select (Crosshair Settings), and press to enter crosshair setting
interface.