Operation Manual

5. Please poke the consumable into the sprayer nozzle for dredging, until the feeding is in
normal condition.
6. Turn off the power for cooling down after the finishing of material dredging.
Adjust the height of the sprayer nozzle
The much too high or low sprayer nozzle will have influence on normal printing (in condition of
much too high sprayer nozzle, the printing material cannot stick on the bottom plate; in condition
of much too low sprayer nozzle, the sprayer nozzle will press the bottom plate, and the printing
material cannot be extruded). Adjust the positioning knob as per the following figure, and adjust
the distance between the sprayer nozzle and the bottom plate: