User's Manual

controller. The Led Indicator on the receiver will be on;
3, You can play by pressing 8-way Directional button and other control buttons.
Operation of the Function
1, Low Power Consumption
To save the power consumption, there is a special “sleeping mode” built into this controller.
The general conditions are as follows:
a, Under the power-on condition for controller, no receiver is found over 15 seconds;
b, Under the disconnection condition, the receiver can’t be re-connected with the controller
over 6 seconds;
c, Under the power-on condition, no any operation acts on any button or axes over 3 minutes;
d, When pressing down the FC group button “Back + Right Thumb” on the controller, but the
“FC” button on the receiver isn’t pressed down over 15 seconds;
e, Under the sleeping mode, you can press “Start”，“Left Thumb” or “Right Thumb” so as to
activate the controller.
2, Definition of Turbo function
a, The buttons “A, B, X, Y, Left Trigger, Right Trigger, White Key, Black Key” can be defined
with Turbo function.
b, Press “Turbo + any action button” at the same time for odd times, the button will be with
Turbo function. Press “Turbo + the defined action button” at the same time for even times,
the defined Turbo function will vanish.
3, Vibration function
While playing, press “Back + Right Thumb” group button at the same time, the motor vibrates
once, which shows the vibration function exits. Press “Back + Right Thumb” group button for
the 2
nd
time, the motor vibrates twice, which shows the vibration function is activated again.
4, Alarm function for lower voltage
When the voltage of the batteries is too low, Macro-Led will keep on flashing, which shows
that the new batteries should be provided, or the original batteries should be recharged. Also
the vibration function is shut off automatically.
5, FC function (short for “Force Connection”) between the appointed controller and the appointed
receiver
You can appoint the RF controller with the appointed receiver when more RF controllers work
in the same operating circumstance. The method is to press down the FC group button “Select
+ Left Thumb” on the controller (or the button “FC” on the receiver), then press the button
“FC” on the appointed receiver (or the FC group button “Select + Left Thumb” on the
controller) within 15 seconds.
6, Macro function (with memory after power off suddenly)
Only “White Key, Black Key, Left Thumb and Right Thumb” buttons can be defined with
Macro function. After definition with Macro function, its original function vanishes. In
addition, the Macro function can be one or more group functions among buttons “A, B, X, Y,
White Key, Black Key, Left Trigger, Right Trigger, D-PAD”. The “Back” button represents as Space
button for use.
A, The definition of Macro function:
a, Press “Macro” button, the Led is on.
b, Press any defined button among “White Key, Black Key, Left Thumb, Right Thumb”,
such as “White Key”;
c, Press a few function buttons and group them as defined functions, such as “A, X, Y, Left