User's Manual

1) PROGRAM sourcing buttons includes: ○, X, □, △, L1, L2, R1, R2, D-PAD
2) The programmable buttons includes: L2,R2,L3,R3.
3) At most 15 times input of sourcing button can be programmed into each programmable button.
4) The latest program setting can be saved once power off.
5) Select button is used as separator when input the same sourcing buttons to set up the program.
6) PROGRAM method:
A. Press MACRO buttons for 3 seconds, the green LED is on.
B. Press the programmable button, such as L3, the green LED will be flashing.
C. Press the PROGRAM sourcing button, such as L1& R1, green LED will be off, PROGRAM setup is
over. Now L3 act as the function of L1& R1.
D. Green LED flashes, when the Macro function is performed.
7) PROGRAM clear up method:
A. Press MACRO button for 3 seconds, the green LED is on.
B. Press the programmable button, such as L3, the green LED will be flashing.
C. Press the MACRO button once more, green LED will be off, PROGRAM is cleared up.
Now L3 resume its default function.
Battery Safety
z Batteries are to be inserted with the correct polarity
z Use only the recommended batteries
z Do not mix old & new batteries
z Do not mix Alkaline, Standard(Carbon Zinc) or rechargeable (Nickel-Cadmium) batteries
z Dispose of batteries safety & correctly
z Do not dispose of batteries in fire, batteries may explode or leak
z Remove batteries if the toy will not be used for a long period of time
z Exhausted batteries are to be removed from the toy
z The supply terminals are not to be short-circuited
z Non-rechargeable batteries are not to be recharged