User's Manual

Page 2
1) No receiver was detected under connection, the gamepad will enter into sleep mode after
fifty seconds;
2) Under connection, no operation on gamepad over ten minutes;
3) Press PS button to exit sleep mode, the LED of working channel light on.
6. Force Connection Function (Short for “FC”)
1) You can assign a RF gamepad to an appointed receiver by FC when more than one RF
gamepads working concurrently(Please reference step 3rd to step 6th of Connection &
Installation );
2) If you want to exchange gamepads or receiver, the FC should be repeated(Please reference
step 3rd to step 6th of Connection & Installation );
3) After finishing of the connection between gamepad and the correspond receiver, automatic
FC function will be realized in the course of using.
7. Low-voltage Alert
When batteries at low, LED will flash. It indicates that batteries should be changed or
recharge in time.
8. Charge for Gamepad
Under connection, when charge for gamepad, LED flash. After charging finished, LED will light on.
Remarks:
 To avoid damage to gamepad, when using non chargable batteries, please don’t charge
with charging line directly;
 Please correctly put batteries into cell case confirm to the position of cathode and
anode;
 Please turn switch off or pull out batteries while no playing with gamepad for a long
time.
9. Troubleshooting
1) When abnormal disconnection or low-voltage protection was occurred will cause
gamepad interruption or no operation can be realized, please power off to restart.
2) Suppose the gamepad no response yet after restarting, please check whether
switch at ON. Connecting cable to charge gamepad. After 30 or 120 minutes,
disconnect cable and power off gamepad.
3) Power on gamepad again and connecting it with receiver follow
Connection &
Installation. After connection, restoration will be realized.