User's Manual

E：USB charging port
F：microphone
2.Pair the earphone with a bluetooth enabled device
Turn the earphone On by long press(around 5 seconds) the power switch,he LED indicator light will quickly blink BLUE.
Keep your bluetooth earphone and bluetooth enabled device within 3feet of each other during the pairing process,set your mobile phone or other bluetooth enabled
device to search for Bluetooth devices.
When the bluetooth enabled device finds the headphone,select” PBT91” from the list of found devices.If required,enter the password 0000.Select Ok or Yes to pair
with your device.
After a successful registration,a tone will be heard and the LED indicator light will slowly blink BLUE.
Note: if you would like to connect the headphones to another device,you must unpair the headphones from the currently paired device first.On your device’s
bluetooth settings,select “PBT91”,then select “unpair”.When the headphones have been unpaired,it automatically goes into pairing mode again.
2.Charging the bluetooth earphone
Connect the small end of the Micro USB cable to the charging port on the earphone. Connect the large end of the Micro USB cable to your computer’s USB port or
an AC adaptor(not included). The LED indicator light turns RED when charging.It will turn off when fully charged.
FCC warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.